Skip to content Skip to sidebar Skip to footer

How to Overcome the Motor Can't Start

How to solve the motor can't start even though it's been started many times? Don't worry, maybe you can check where the problem is.

How to Overcome the Motor Can't Start

The motor cannot be started is a problem that is often experienced by the owners of these two-wheeled vehicles, usually this happens in the morning. Especially if you are in a hurry to get to the office on time. Because the vehicle is difficult to start late to work.

Therefore, you must know what causes it and how to fix it. There are several alternative ways that are quite effective for dealing with difficult-to-start motors.

How to Overcome the Motor Can't Start

There are several reasons why the motor won't start. Make sure you pay attention to the following.

1. Check Component Problem

Make sure you check the problematic components, such as the battery, starter system, spark plugs, starter relay, and carburetor.

2. Make sure the battery is sufficient. Enough

The battery component that functions to store electricity is one of the uses for engine servicing. If the voltage from the battery decreases, the performance of the electronic components in other motors will also decrease, including the engine starter. Check if the battery charging is running smoothly.

3. Unlocking the Starter System

Usually the motor dies due to a short circuit in the starter system. The trick, check if there are burn scars. The solution is to remove the short circuit, then reinstall the fuse component by adding an insulator to prevent repeated short circuits.

4. Check Spark Plug

This spark plug can be regarded as a component that is quite often replaced with new ones. The spark plug wire is also one of the parts that connect the spark plug cap and coil which can be the cause.

5. Carburetor Problem

In injection motors, the carburetor functions to flow fuel and air into the engine cylinders. If there is damage to this section, then the fuel supply is not perfect. The fix is ​​to check the fuel pressure first. You can open the carburetor by turning and adjusting it. Just turn it clockwise and turn it counterclockwise again.

6. Check Fuel Flow to Engine

If there is no problem with the carburetor, it could be the hose. The high position of the tank actually makes it easier for gasoline to get down to the engine. It's just that there are often errors in the hose, whether it's clogged or the motor is rarely used. Since the motor is rarely used, the fuel flow in the hose can dry out. As a result the motor will not start no matter how many times you press the starter. The way to fix the motor can't start because of this problem is to remove the radiator hose. Remove from clamp and let it drain.